I installed a pair of corbeau suspension seats in my 2007 2 door Wrangler last night but the brackets donít allow for the airbag sensor wiring. The installation section says you no longer use them. This causes the airbag light on the dash to go on and the passenger side airbag to be off. Has anyone found a solution to fixing this so the passenger side airbag works and the airbag dash light turns off? Contemplating returning the seats and reupholstering my current seats. Corbeau seats are also incredibly snug causing rubbing on roll bar and not allowing seat to slide back much at all (hits the seat belt area on the floor). Iíve reached out to Corbeau about this. Thanks for any help!!